Lockjaw Wire Anchor | Espalier Kit – Diamond Queen
51497
page,page-id-51497,page-template-default,qode-core-1.0.3,ajax_fade,page_not_loaded,boxed,brick-ver-1.8, vertical_menu_with_scroll,smooth_scroll,,wpb-js-composer js-comp-ver-4.12.1,vc_responsive

Espalier Kit – Diamond Queen

Starter kit for a queen diamond espalier installation

With this kit you will get all the components you require to install a queen diamond patterned espalier set-up as shown in the diagram below. (Wire not included) This creates a stylish pattern when growing with vines such as star jasmine, clematis or bougainvillea. Ideal to turn a wall or fence into a growing work of art. This system can be used for fixing onto timber fences, concrete block or brick substrates using screw plugs. Use either 2 mm stainless steel wire rope or 2 mm soft wire.

Diamond-queen
CAUTION : DO NOT FORCE WIRE THROUGH ANCHOR
Gently insert wire using back and forth motion until wire slides comfortably between the locking jaws.
tools-surface-components

REQUIRE TOOLS

The only tools you will require to complete this job are a power drill with a hex driver bit (available from our store), pop rivet gun and wire cutters.

h2-diamond1

STEP 1

Plan your job carefully – this set up uses 1 run of wire. Measure and markout your mounting points – note that the distance between these points should be equal for both vertical and horizontal.

h2-diamond2

STEP 2

Fix the anchor platforms in place at each corner ensuring that they are set at a 45° angle.

h2-diamond3

STEP 3

Fix the radial wire guides at the intermediate positions – the guide should be vertical and horizontal as shown in corresponding position on the diagram. Also ensure the guide is the correct way around – one end has a groove for the wire to follow.

h2-diamond4

STEP 4

Insert wire through anchor platform and into lockjaw anchor to hold in place. Note caution above.

h2-diamond5

STEP 5

Uncoil wire an feed through radial wire guides to the end point following the numbers on the above diagram.

h2-diamond6

STEP 6

Fit lockjaw anchor at end point then tension wire with pop rivet gun. Trim wire and fit caps at both ends.

Get this diamond espalier starter kit.

This kit provides all the components required to install a diamond set-up as shown in the above diagram.

(Wire not included)

A regular fence panel 2.5m x 2m requires 14m of wire.

We recommend Stainless Steel Wire Rope.

SHOP NOW

We accept Pay Pal, Visa, Mastercard and Internet Banking.