Lockjaw Wire Anchor | Espalier Kit – Light-weight
51287
page,page-id-51287,page-template-default,qode-core-1.0.3,ajax_fade,page_not_loaded,boxed,brick-ver-1.8, vertical_menu_with_scroll,smooth_scroll,,wpb-js-composer js-comp-ver-4.12.1,vc_responsive

Espalier Kit – Light-weight

Starter kit for light-weight surface installation

With this kit you will get all the components you require to install a 2.0mm, 4 wire ladder espalier set-up as shown in the diagram below.

(Wire not included)

LW-surface-kit
CAUTION : DO NOT FORCE WIRE THROUGH ANCHOR
Gently insert wire using back and forth motion until wire slides comfortably between the locking jaws. 
tools-surface-components

REQUIRED TOOLS

The only tools you will require to complete this job are a power drill with a hex driver bit (available from our store), 3mm drill bit, pop rivet gun and wire cutters.

h2g_0009_measure

STEP 1

Plan your job carefully. Measure and markout your mounting points.

h2g_0008_fixPlaform

STEP 2

Fix Anchor Platforms at beginning and end of the wire run.

h2g_0010_drill

STEP 3

Pre-drill holes for eye screws at intermediate fixing points with 3mm bit.

h2g_00058_eyescrew

STEP 4

Screw eye screws in place being sure that they are in as far as they can go.

h2g_0006_feed

STEP 5

Starting at the bottom anchor platform and begin feeding wire, going back and forth along each run, before inserting guide plugs or anchors.

h2g-wireinplace

STEP 6

The wire should now be treaded through each end and still sitting loose through the eye screws.

h2g_0007_Anchor-feedwire

STEP 7

At end point, carefully insert wire through Lockjaw anchor and push anchor into the platform. Repeat this at the other end, leaving the wire loose until after Step 8. Note caution above.

h2g-loosefitguides1

STEP 8

Before you tension the wire, slip guide plugs onto wire and insert into eye screws. Ensure the direction of the wire follows the groove on the top of the guide plug.

h2g_0000_tension

STEP 9

With the guide plugs now in place, tension the wire at the anchor ends using a pop rivet gun. The wire should be just tight enough to remove any sag.

h2g-trim-capend

STEP 10

Using your wire cutters, trim wire flush with the Lockjaw anchor and fit the end cap.

h2g_0002_tensionwire-trim-rev

STEP 11

At the other end excess wire is needed for future tensioning if needed. Fit tension cap with the wire protruding then trim flush with end of cap.

Get the lightweight espalier starter kit.

This kit provides all the components required to install a 4 wire set-up as shown in the above diagram.

(Wire not included)

SHOP NOW

We accept Pay Pal, Visa, Mastercard and Internet Banking.